X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • nepenthes
    replied
    Hey Mike! If your cuttings are starting to leaf out, maybe it's time for them to start getting used to "normal" humidity? I didn't know what your current plans are with them so ignore my advice if I'm wrong. It took me about 4 days to get my fully leafed out cuttings from 80-99% humidity to ~44%. It was a great feeling when the cuttings didn't have to rely on a "bin" anymore. Plus, it's fewer issues I had to worry about!

    Leave a comment:


  • fitzski
    replied
    Mike,

    I had the same issue until I started giving more fresh air to the cuttings. Now every morning and night I open the lid and move it back and forth over the bin so some of the air in the bin gets "changed". It seems to be helping so far. The mold has stopped and there appears to be more leaf/branch growth now.

    Leave a comment:


  • F. Bennett
    replied
    Brett is absolutely right. It's very common that I lose small leaves while in the bin, but more sprout and all ends up well. I wouldn't worry too much about it. Just keep an eye out for dieing branches.

    Leave a comment:


  • Taverna78
    replied
    Sì,
    Makes sense. I will start to leave lid a bit more open now

    Leave a comment:


  • Taverna78
    commented on 's reply
    Oh trust me is opened religiously at least once a day. Realistically if the cuttings are rooted and leafing out I think I remember you saying try getting them out of humidity anyway correct?

  • brettjm
    replied
    Mold happens, in my limited experience. I agree that your humidity is probably too high, and they need a little fresh air. If its on the leaf, don't be surprised if you lose the leaf. Losing leaves is SUPER common on young cuttings. Heck, several of mine dropped all their leaves and then started fresh due to overwatering. In the end, they're pretty tough. In this case, addressing the cause of the problem is probably more important than addressing the problem itself (if that makes sense).

    Leave a comment:


  • WillsC
    replied
    Mike,

    The mold is just on the outside....it is probably due to a little too much humidity and not enough fresh air, give it a little fresh air every day and should be fine. Mold is everywhere......in every step you take you are moving mold spores around.

    Leave a comment:


  • Taverna78
    started a topic Fuzz white mold on new cutting leaf?

    Fuzz white mold on new cutting leaf?

    I have bin with many rooted cutting that are sprouting new leaf. And 2 out of say 20 has little white fuzzy mold on a leaf. It is in humidity bin with light ? What to do? Adding to tis oddly enough its same type of fig and there is different types between the two that are fine. Does mold live inside a cutting? Or just topical?
    Last edited by Taverna78; 04-29-2015, 06:36 AM.
Working...
X